On July 26, 2019, the Environmental Protection Agency (EPA) proposed revisions that would allow an operating facility to be reclassified from a major source of hazardous air pollutants under Section 112 of the Clean Air Act to an area source, thus removing the policy commonly known as “once in, always in”. This revision could take a lot of pressure for capital investments and permitting off of facilities that are eligible.
Continue reading “EPA Allows Reclassification from A Major Source of Hazardous Air Pollutants (HAP) to An Area Source” →
On September 6, 2019, the EPA published a proposed amendment to what is commonly referred to as the Plywood or Kiln MACT. This proposed amendment does not address lumber kiln emission standards. EPA has stated that the lumber kiln emission and work practice standards will be addressed in a later proposed amendment.
This proposed amendment to 40 CFR 63, Subpart DDDD: National Emission Standards for Hazardous Air Pollutants (NESHAP) for Plywood and Composite Wood Products (PCWP) is based on the completion of the residual risk and technology review. The review has found that no revisions are necessary to the current controls in the original rule. The rule does propose removal of the startup, shutdown, and malfunctions plans as EPA has deemed this to be sufficiently addressed in the work practice standards of the regulation, as well as by the Clean Air Act (CAA).
The proposed rule is open to comments until October 21, 2019. All submissions must include Docket ID No. EPA-HQ-OAR-2016-0243-0034. The EPA encourages that comments be submitted through the Federal eRulemaking Portal located at https://www.regulations.gov/.
If you need help identifying how this proposed rule change will affect your facility or need assistance with providing comments to the EPA, please contact us at (770) 263-6330 or firstname.lastname@example.org.