The EPA Information Collection Request (ICR) for Plywood and Composite Wood Products (PCWP) Maximum Achievable Control Technology (MACT) for Dry Kilns is in its Final Approval Stage

The Environmental Protection Agency (EPA) has submitted an information collection request (ICR), for the “Plywood Composite Wood Products National Emission Standards for Hazardous Air Pollutants (NESHAP) Risk  and Technology Review (RTR)” (Kiln MACT) to the office of Management and Budget (OMB) for preview and approval.

This Kiln MACT applies to every sawmill that is a Major Source or Synthetic Minor Source for Hazardous Air Pollutants (HAP).

The ICR will be sent to all known operators of PCWP facilities that are major sources for hazardous air pollutants (HAP) regulated by the PCWP NESHAP and synthetic area sources that may have used technology to avoid major source status triggering NESHAP applicability. The information collection seeks to collect facility-level information (e.g. facility name, location, contact information, and process unit details), emissions information, compliance data, control information, and descriptions of technological innovations.

The EPA will either establish an emission limit or work practices in order to minimize emissions for process units included in the PCWP MACT source category. Capturing, controlling, and the measurements of kiln emissions is not feasible. Installing emissions capture and add-on control equipment for VOC/HAP removal have not been identified. It is therefore predicted that facilities will choose to use work practice requirements in lieu of emission limits.

The purpose of work practices is to minimize HAP emissions. For most kiln schedules, the HAP emissions increase near the end of the drying cycle when the wood reaches its final moisture content. HAP emissions increase as the moisture content decreases.

If you operate a lumber kiln, you will need to develop a plan for minimizing HAP emissions from the lumber kiln(s) by minimizing the annual average variability in dried lumber moisture content. Plans must be required to be submitted to the appropriate regulatory agency with your Notice of Compliance Status and you will need to maintain appropriate records of compliance with the work practices.

Changes in kiln operating temperatures can significantly affect mill operations and drying capacity. Lower kiln temperatures result in longer drying times. This is a production and capacity issue for mills. A mill operating four lumber kilns at full capacity at 225OF would have to add two more lumber kilns to dry the same amount of lumber at 180OF. To overcome the potential Kiln MACT limitation, facilities will need to prepare a compliance work practice plan that minimizes emissions with the least affect to drying production.

Shortly Major Source and Synthetic Minor Source of HAPs will receive an ICR survey. You will have 120 days after ICR mailout to submit it. CTI is experienced in this area in assisting many lumber mills in the permitting process that includes most of the information requested in the survey. CTI also has assisted facilities with ICR for other regulations in the past.

Upon receipt of the ICR, feel free to contact us for a proposal to assist you to prepare it. If you have any questions or need additional information, please contact us.

Leave a Reply

Your email address will not be published.